
Secondary coil and sheet still have a market.
Flat rolled steel builds up as secondary stock: coils with surface defects, off-spec sheet, end-of-coil lengths, cancelled orders and fabrication remnants. It is too good to scrap but hard for a stockist to sell through normal channels.
We value prime and secondary material on its resale potential, using the grade, thickness, width, coating and condition. Offcuts and skeleton scrap are priced at the ferrous scrap rate.
We also buy structural steel and other ferrous metals, and stainless and aluminium sheet.
Flat rolled products we purchase
Hot rolled coil & sheet
HRC, pickled and oiled coil and cut sheet.
Cold rolled coil & sheet
CRC and cold rolled sheet in all thicknesses.
Galvanised steel
GI coil and sheet, hot-dip and electro-galvanised.
Pre-painted steel
PPGI coil, roofing and cladding sheet.
Steel plate
Mild steel and high-strength plate, full sheets and part sheets.
Chequer plate
Chequer and tread plate for flooring and platforms.
Strip & slit coil
Narrow strip, slit coils and edge trim.
Secondary & defect coil
Off-spec, surface-defect and end-of-coil material.
Offcuts & skeleton
Laser and press offcuts, skeleton scrap and remnants.
Not on the list? If it is surplus and has value, ask us. We probably buy it.
What affects the price
No two lots are the same. These are the factors we look at when valuing flat rolled products.
| Factor | Why it matters |
|---|---|
| Prime or secondary | Prime material with full specification resells for much more than secondary. |
| Grade & coating | Galvanised, pre-painted and high-strength grades carry more value. |
| Thickness & width | Standard, usable sizes are easier to resell than odd widths and gauges. |
| Condition | Rust, damage and moisture lower the value. Dry, banded coils resell best. |
| Quantity & logistics | Full coils and consistent lots are easier to resell, while loading equipment matters. |
What to send us
The more we know up front, the sharper the first figure. Rough numbers are fine.
- A stock list with grade, coating, thickness, width and weight
- Photos of coils and stacks plus close-ups of labels and tags
- Whether the material is prime, secondary or offcuts
- Location, loading equipment (coil lifter or crane) and your deadline
Four simple steps
- Inquiry: send photos, a list or quantities by the quote form, phone or email.
- Valuation: we reply with an indication, typically within 12 hours, and visit the site to confirm where needed.
- Payment: agree the figure and get paid quickly, with no drawn-out terms.
- Pickup: our team loads and removes the material anywhere in the Emirates.
Flat Rolled Products: common questions
Do you buy secondary and defect coils?
Yes. Secondary material is a large part of what we buy and is valued for resale where possible.
Do you buy galvanised and pre-painted steel?
Yes. GI and PPGI coil and sheet are bought, including roofing and cladding sheet.
Do you buy fabrication offcuts?
Yes. Offcuts and skeleton scrap are bought at the ferrous scrap rate.
How is flat rolled steel priced?
Usually by weight. Prime and secondary material is priced above scrap based on its specification and condition.
Related categories and service areas
Selling flat rolled steel?
Tell us what you have. We reply with a no-obligation valuation, typically within 12 hours.